User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 3: Operation
98-148232-B Status of the EXPLORER 540 36
Log file(s)
Using AT commands, you can command the EXPLORER 540 to send the following log files to
an FTP server:
•Diagnostics report: diagreport.tar.gz. A report containing useful information for
troubleshooting (includes the logs below as well as other information).
•Event log: event.csv. A log of events that are signalled to the user.
•System log: syslog.log. A log of internal events in the EXPLORER 540.
• AT command log: at_log.txt. A log of all AT commands sent and received by the
EXPLORER 540.
To command the EXPLORER 540 to send a log file to an FTP server, do as follows:
1. To access the EXPLORER 540, use one of the following:
• a computer connected to the Internet, see Remote access with AT commands on
page 24, or
• equipment connected to a cellular network, see Remote access with SMS on page 20.
Note that you need a password for both access methods. For AT commands, use the
AT_ICLCK command with the admin password, for SMS, use the remote SMS password.
2. Send the command _ISENDFILE to the EXPLORER 540 to make it send a log file to the
specified destination on your FTP server.
Example: _ISENDFILE="/","syslog.log","ftpdirectory","ftp.myftpserver.com","ftp-
username","ftp-password"
In this example. the terminal will look for a file named syslog.log in the local directory / in
the terminal, and send the file to the directory ftpdirectory on the FTP server named
ftp.myftpserver.com. The user name ftp-username and password ftp-password give
access to the FTP server. The APN is left out to indicate that the default APN is used.
3. You get a response command that the file was transferred successfully.
Example: _ISENDFILE: 0, Complete
Using the web interface you can see the Event log and create a diagnostics report. See Log files
on page 86.
Status of the EXPLORER 540
There are basically three ways of getting status from the EXPLORER 540:
• Access the built-in web interface. The Status page shows information such as terminal
status, network status, position status and ongoing communication. See Status
information on page 45.
• Send the SMS command GETINFO to the EXPLORER 540. This commands retrieves
information from the EXPLORER 540 such as call time, data usage, GPS position and global
IP address. For details, see ATCO commands on page 100