User Manual

Chapter 4: Configuration with web interface
98-148232-B To control data connections from web interface 42
To control data connections from web interface
The startup page of the web interface is used to start and stop data connections and to set up
the data connections.
To start and stop data connections
By default, you must activate your data connection before you can access the Internet.
However, you can enable automatic activation of a data connection. See step 3. on page 51.
To start and stop data connections on your EXPLORER 540, do as follows:
1. In the opening page, locate the connection package you want to start.
2. Click
 to start the connection. The connections icon at the bottom of the page shows
when a BGAN data connection package is running.
3. Click
 to stop the connection.
If the connection fails, the connection tile shows an exclamation mark
 and an error
message. The error message is also shown in the data log, see Data log on page 48.
When a connection is active, the icon changes to
 and the tile for the active connection
shows:
• IP address: The external IP address that has been assigned by the service provider to this
session. If the connection was started by remote SMS, the local IP address is also shown.
• Transferred data: For Standard data, the tile shows the total amount of transmitted and
received data since the connection was established.
Note
With a non-M2M subscription you have more options for the data connection. See
Appendix C, BGAN non-M2M functions.
Note
The icons for starting  and stopping  connections are only active if the terminal
is ready and registered on the BGAN network. Otherwise the text is greyed out and
you cannot start data connections.