User Manual

Chapter 4: Configuration with web interface
98-148232-B To set up your data connection packages (BGAN M2M) 43
To set up your data connection packages (BGAN M2M)
To change the name of a connection package
To change the name of a connection package, click  in the right side of the tile with the
connection package.
Click Properties, type in the new name and click Save. The new name is shown on the tile on
the startup page.
To change the APN for a connection package
By default a connection package is set to use no IP Header compression and to use the APN
(Access Point Name) from the SIM card. This is suitable for most applications.
If you want to use a different APN, do as follows:
1. Click
 in the right side of the tile with the connection package that you want to change.
2. Select Parameters.
3. Next to APN, select the source of the APN.
• SIM default (default and recommended setting): The APN is taken from the SIM card.
• Network assigned: The APN is assigned from the network.
• User defined: APNs are provided from the Airtime Provider. Type in the APN next to
User defined name.
4. If your APN uses a password, type in the User name and Password provided from the
Airtime Provider.
5. Click Save.
Note
This section only describes the Standard data connection available with M2M
subscriptions. For information on class 2 subscription, see To set up data connections
on page 110.
Note
You must be logged in as administrator to be able to change the settings for a data
package.
Note
It is recommended to leave IP Header compression disabled. This means that the
data packets are transmitted more reliably with less data loss.