User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 4: Configuration with web interface
98-148232-B Terminal settings 50
To set up the connection mode
In the web interface you can set up the Internet connection mode and the IP addressing
between the EXPLORER 540 and devices connected to the EXPLORER 540. The EXPLORER 540
has a built-in DHCP server which can be used to dynamically assign IP addresses to devices
connected to the EXPLORER 540.
The drawing below shows examples of the IP addressing in router mode (default setup) and
modem mode.
5RXWHUPRGH
'HIDXOWVHWXSH[DPSOH
7HUPLQDO
'HYLFH
'HYLFH
Q
DVVLJQHGE\WKH
WHUPLQDOYLD'+&3
P
DVVLJQHGE\WKH
WHUPLQDOYLD'+&3
%*$1QHWZRUN
'+&3VHUYHU
DVVLJQHGE\WKH%*$1
QHWZRUNYLD'+&3
0RGHPPRGHZLWKDFWLYHFRQQHFWLRQWRWKH%*$1QHWZRUN
([DPSOH
'HYLFH
7HUPLQDO
,3DGGUHVVWRDFFHVVWKHWHUPLQDO¶VZHELQWHUIDFH
P
DVVLJQHGE\WKH%*$1
QHWZRUNYLD'+&3
Q
1$7'+&3
%*$1QHWZRUN
'+&3VHUYHU
Q
0RGHPPRGHQRFRQQHFWLRQWRWKH%*$1QHWZRUN
([DPSOH
7HUPLQDO
%*$1QHWZRUN
'+&3VHUYHU
Q
'HYLFH
/RFDO,3DGGUHVV
'+&3
Q
DVVLJQHGE\WKH
WHUPLQDOYLD'+&3