User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 4: Configuration with web interface
98-148232-B Support features 60
3. Select Download report.
4. Choose a location for the file and save it.
To update software
To update the software in the EXPLORER 540 using the web interface, do as follows:
1. Download the new software
1
or acquire the software from Cobham SATCOM and save it
on your computer.
2. Open the web interface and enter the Control panel
.
3. Click Support > Update software.
4. Click Update software...
5. Browse to the new software version and click Open. The software file has the extension
“.tiif”.
6. The terminal restarts and completes the software update.
You can check the software version under Control panel > Support > About.
To view extended status
To see the Extended status page, select Support > Extended status.
To view updated information on the Extended status page, click the icon in the top left
corner to refresh the page.
The Extended Status page shows information such as IAI-2 status, IMSI number and IMEI
number.
1. You can download the software from the “Self Service Centre” at www.cobham.com/satcom,
select
Service and Support > Cobham SATCOM Service and Support and then 24-7 Self
Service Centre / Technical Downloads. Locate the EXPLORER 540 software.
Note
The update procedure takes some minutes to complete. If the installation
process has not yet been completed, the Status LED flashes blue during the
software update.