User Manual

Chapter 4: Configuration with web interface
98-148232-B Advanced settings 63
3. Type in the Old password.
4. Type in the New password and retype it on the next line.
5. Click Save.
At the next login the new password is required.
To log out as administrator
If you close the web interface, you are logged out automatically after 30 seconds. To log out
manually, click Logout administrator in the Advanced page.
To set up user permissions
You can allow or deny users access to certain functions and make these pages read-only. This is
useful if you want to protect the system against unintended changes. Study this screen
thoroughly and decide to which areas of the system you want to give non-administrator users
access. To set up the user permissions, do as follows:
1. Under Advanced, select User permissions.
2. Under Allow users to:, select the settings you want to allow users to access.
3. Under Allow AT commands on:, select LAN interface if you want to allow the use of
AT commands.
4. Under Allow user accounts:, select Service user account if you want to enable the
use of a service user account.
5. Click Save.
The settings without a check mark can only be viewed but not changed by the non-
administrator user.
To restore factory settings
To restore the factory settings of the EXPLORER 540, do as follows:
1. Under Advanced, select Factory reset.
2. Click OK.
The terminal will now restart and start up with the factory settings. The installation process
is also restarted.
Important
All configuration will be lost and the EXPLORER 540 will return to the default
configuration.