User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 4: Configuration with web interface
98-148232-B Advanced settings 67
Data limits
You can set a limit for the use of data services with the EXPLORER 540 system.
If you have entered the call charges in the menu Call charges, the system automatically
calculates and displays the estimated maximum charges for your data sessions.
Once the entered limit is reached, the connection is automatically stopped. This is recorded in
the data log. To continue using the data service you must start a new connection by clicking on
the desired connection on the startup page.
To set data limits, do as follows:
1. Under Advanced, select Data limits.
2. Select the type of connection you want to limit.
3. Type in the amount of data or time allowed and select the appropriate units.
4. Select Enable.
5. Click Save to save the settings.
Call charges
If you know the tariff for your subscribed services, you can enter these tariffs in the web
interface and automatically calculate the estimated charges for your calls and data sessions. To
enter the call tariffs, do as follows:
1. Under Advanced, select Call Charges.
2. Select the currency from the Displayed currency drop-down list.
3. Enter the tariff for each of the services.
4. Click Save.
The entered tariffs are used for estimating the charges for calls and data sessions. For
further information, see Call log (Non-M2M only) on page 48.
Note
Thrane & Thrane A/S does not take responsibility for the correctness of the estimated
charges. This calculation is only a rough estimate of the charge, based on the tariff
entered by the user. Also, the airtime provider may have different methods of
calculating the charge.
Note
If you have enabled automatic activation of the Standard data connection and you
set a data limit for the Standard data connection, automatic activation is disabled.
Note
Thrane & Thrane A/S does not take responsibility for the correctness of the estimated
charges. This calculation is only a rough estimate of the charge, based on the tariff
entered by the user. Also, the Airtime Provider may have different methods of
measuring the airtime used.