User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 4: Configuration with web interface
98-148232-B Advanced settings 69
To set up remote access with IP
1. From the Remote management page, select Enable access to web application and/
or Enable access to AT commands.
2. Type in the Incoming port numbers to use for the web server and for AT commands.
The default port numbers are:
•web server: 80
• AT commands: 5454
3. Under Trusted IP addresses, click Add IP address and type in the IP address of the
device you want to give access to the terminal.
4. To add more IP addresses, click Add IP address again.
After preparing the terminal and activating the connection you can access the terminal from
one of the trusted IP addresses, using the incoming port defined in the Incoming port field.
• For information on how to prepare the terminal for remote activation of a data
connection, see the next section To set up remote access with SMS.
• For information on how to access the terminal, see To access the terminal from a
remote location on page 20.
If Static IP is included in your airtime subscription, we recommend using this static public IP
address for the terminal in order to provide easy access to the terminal. To use the static IP
address, it must be included in your airtime subscription and you must set the APN source to
SIM default. For details, see To change the APN for a connection package on page 43.
To set up remote access with SMS
1. From the Remote management page, select whether you want to Enable remote
SMS commands.
2. Enter the password for remote SMS. It can be up to 32 characters long. The characters 0-9,
a-z and A-Z are allowed. The password is mandatory. This password must be entered
every time you send an SMS command. Default password is remote.
Note
The settings for Remote access with IP are not relevant if you are using the
_IREMWEB command. See To use AT commands to get remote access to the web
interface on page 25.
Note
If you type another port number, the port number must be available at your
service provider.
Note
To be able to access the terminal you must have an active data connection.
Note
The terminal must be registered to the satellite services to receive and accept an SMS.