User Manual
Table Of Contents
- Safety summary
- Antenna safety instructions
- About this manual
- Introduction to EXPLORER 540
- To get started
- Operation
- Configuration with web interface
- The web interface
- To control data connections from web interface
- To set up your data connection packages (BGAN M2M)
- Status information
- The Control panel
- To restart the installation process
- To use the logs
- Terminal settings
- Port forwarding
- To manage connected devices (Traffic control)
- To set up tracking
- Support features
- Advanced settings
- To enter the SIM PIN in the web interface
- Maintenance and troubleshooting
- Technical specifications
- Command reference
- BGAN non-M2M functions
- Conformity
- Glossary
- Index
Chapter 4: Configuration with web interface
98-148232-B Advanced settings 71
Power save (Settings)
There are a number of options to save power in the EXPLORER 540. For a general description of
the power save options, see Power-saving on page 31.
To set up the power save options, do as follows:
1. Under Advanced, select Settings.
2. Select how many minutes with no (local) activity before the terminal should enter power
save mode (Idle time).
3. Select Prevent power save if satellite connection is active if you do not want the
terminal to enter power save mode when a data connection (PDP context) is opened on
the satellite connection.
4. Select Enable daily wake up and enter the Wake up time of day if you want the
terminal to “wake up” from power save mode at a specific time every day.
Note
If you select 0 (zero), the power save function is disabled and the terminal will
never enter power save mode.
Note
With this option selected, the terminal will not enter power save mode if there is
a PDP context open, even if it is not currently used to send or receive data.