User's Manual
Table Of Contents
- Safety summary
- Preface
- Training information
- About this manual
- Introduction
- Installation
- Interface description
- Configuration
- Service & maintenance
- Technical specifications
- NMEA sentences
- B.1 NMEA sentences used
- B.2 Sentence use reference
- B.2.1 ABK - AIS addressed and binary broadcast acknowledgement (output)
- B.2.2 ABM - AIS addressed binary and safety related message (input)
- B.2.3 ACA - AIS channel assignment message (input / output)
- B.2.4 ACK - Acknowledge alarm (input)
- B.2.5 AIR - AIS interrogation request (input)
- B.2.6 ALR - Set alarm state (output)
- B.2.7 BBM - AIS broadcast binary message (input)
- B.2.8 DTM - Datum reference (input)
- B.2.9 EPV - Command or report equipment property value (input / response output)
- B.2.10 GBS - GNSS satellite fault detection (input)
- B.2.11 GGA - Global positioning system (GPS) fix data (input)
- B.2.12 GNS - Fix data (input)
- B.2.13 HBT - Heartbeat supervision sentence (input)
- B.2.14 HDT - Heading true (input)
- B.2.15 LR1 - AIS long-range reply sentence 1 (output)
- B.2.16 LR2 - AIS long-range reply sentence 2 (output)
- B.2.17 LR3 - AIS long-range reply sentence 3 (output)
- B.2.18 LRF - AIS long-range function (input / output)
- B.2.19 LRI - AIS long-range interrogation (input / output)
- B.2.20 NAK - Negative acknowledgement (output)
- B.2.21 PTHRAOC - AIS operational control (input / output)
- B.2.22 PTHRROS - Radio operational status (output)
- B.2.23 RMC - Recommended minimum specific GNSS data (input)
- B.2.24 ROT - Rate of turn (input)
- B.2.25 SPW - Security password sentence (input)
- B.2.26 SSD - AIS ship static data (input / output)
- B.2.27 THS -True heading and status (input)
- B.2.28 TRL - AIS transmitter non functioning log (output)
- B.2.29 TXT - Text transmission (output)
- B.2.30 VBW - Dual ground/water speed (input)
- B.2.31 VDM - AIS VHF data-link message (output)
- B.2.32 VDO - AIS VHF data-link own-vessel report (output)
- B.2.33 VER - Version (output)
- B.2.34 VSD - AIS voyage static data (input / output)
- B.2.35 VTG - Course over ground and ground speed (input)
- B.2.36 ZDA - Time and Date (output)
- Supported keys
- Glossary
- Index
Index
98-137573-A Index-3
5555
Index
NMEA tracer, 5-20
O
on/off control, 4-2
open source licences, 5-4
P
part numbers, 2-7
accessories, 2-7
password, 5-6
admin level, 5-11
change, 5-11
reset, 5-11
user level, 5-11
PI settings, 5-12
pilot plug, 2-4
connection, 4-8
SAILOR 6283 AIS Connection Box and Wall
Tray
, 4-8
pin allocation
DC connector
, 4-1
pilot plug, 4-8
SUB-D50, 3-14
position
fixing device
, 5-10
GNSS antennas, 4-4
reference points for GPS antenna, 5-10
power connector, 3-8
presentation interfaces, 2-5, 4-6
baud rate, 4-7
schematics, 4-7
R
radar, 2-2
distance to antenna installation, 3-4
Rate of Turn, 4-5
reboot
power cycle
, 5-18
recover communication, 6-12
remote on/off
connect
, 4-2
remove AIS Transponder, 6-3
reporting interval, A-2
reset, 5-18
password, 5-11
restore, 5-18
restore from file, 5-18
RF exposure, -iii
ROT, 2-5
RS 422 interfaces, 4-4
S
safety distance, -iii
SAILOR 6280 AIS System
cable specifications
, 3-11
components, 3-6
wiring, 3-10
SAILOR 6281 AIS Basic System
cable specifications
, 3-16
components, 3-12
wiring, 3-16
salt deposits, 6-1
satellite equipment
distance to antenna installation
, 3-4
self test, 5-4
Sensor
NMEA sentences
, 5-13
sensor inputs, 2-5, 4-3
baud rate, 4-4
schematics, 4-3
termination, 4-3
Sensor settings, 5-13
Service Interface
access
, 5-4
settings
Ethernet
, 5-15
jumper, AIS Connection Box, 3-9
LWE, 5-16
PI, 5-12
sensor, 5-13
ship name, 5-8
ship type
table
, 5-9
software
uninstall
, 5-3, 5-4
software license, -ii
software update
TMA
, 6-2
software version
TMA
, 5-5
specifications, A-1
SUB-D 50 connector
pin allocation
, 3-14
SUB-D50 connector, 3-14