User's Manual
Table Of Contents
- Safety summary
- Preface
- Training information
- About this manual
- Introduction
- Installation
- Interface description
- Configuration
- Service & maintenance
- Technical specifications
- NMEA sentences
- B.1 NMEA sentences used
- B.2 Sentence use reference
- B.2.1 ABK - AIS addressed and binary broadcast acknowledgement (output)
- B.2.2 ABM - AIS addressed binary and safety related message (input)
- B.2.3 ACA - AIS channel assignment message (input / output)
- B.2.4 ACK - Acknowledge alarm (input)
- B.2.5 AIR - AIS interrogation request (input)
- B.2.6 ALR - Set alarm state (output)
- B.2.7 BBM - AIS broadcast binary message (input)
- B.2.8 DTM - Datum reference (input)
- B.2.9 EPV - Command or report equipment property value (input / response output)
- B.2.10 GBS - GNSS satellite fault detection (input)
- B.2.11 GGA - Global positioning system (GPS) fix data (input)
- B.2.12 GNS - Fix data (input)
- B.2.13 HBT - Heartbeat supervision sentence (input)
- B.2.14 HDT - Heading true (input)
- B.2.15 LR1 - AIS long-range reply sentence 1 (output)
- B.2.16 LR2 - AIS long-range reply sentence 2 (output)
- B.2.17 LR3 - AIS long-range reply sentence 3 (output)
- B.2.18 LRF - AIS long-range function (input / output)
- B.2.19 LRI - AIS long-range interrogation (input / output)
- B.2.20 NAK - Negative acknowledgement (output)
- B.2.21 PTHRAOC - AIS operational control (input / output)
- B.2.22 PTHRROS - Radio operational status (output)
- B.2.23 RMC - Recommended minimum specific GNSS data (input)
- B.2.24 ROT - Rate of turn (input)
- B.2.25 SPW - Security password sentence (input)
- B.2.26 SSD - AIS ship static data (input / output)
- B.2.27 THS -True heading and status (input)
- B.2.28 TRL - AIS transmitter non functioning log (output)
- B.2.29 TXT - Text transmission (output)
- B.2.30 VBW - Dual ground/water speed (input)
- B.2.31 VDM - AIS VHF data-link message (output)
- B.2.32 VDO - AIS VHF data-link own-vessel report (output)
- B.2.33 VER - Version (output)
- B.2.34 VSD - AIS voyage static data (input / output)
- B.2.35 VTG - Course over ground and ground speed (input)
- B.2.36 ZDA - Time and Date (output)
- Supported keys
- Glossary
- Index
SAILOR 6282 AIS Transponder
A-2 Chapter A: Technical specifications 98-137573-A
A.1.1 Reporting Intervals
The SAILOR 6282 AIS Transponder is transmitting in different intervals depending of the
dynamic input data as speed and turn. The reporting intervals are as follows:
Type of information Reporting interval
Static Information Every 6 min. or when data has been amended
and on request.
Dynamic Information Depending on speed and course alteration,
see the table below.
Voyage related
information
Every 6 min. or when data has been amended
and on request.
Safety related message As required.
Table A-2: Reporting intervals
Type of ship
Reporting
Interval
Ship at anchor or moored and not moving faster than
3 knots
3 min
Ship at anchor or moored and moving faster than 3 knots 10 s
Ship with a speed of between 0 - 14 knots 10 s
Ship with a speed of between 0 - 14 knots and changing
course
3 1/3 s
Ship with a speed of between 14 - 23 knots 6 s
Ship with a speed of between 14 - 23 knots and changing
course
2 s
Ship with a speed of greater than 23 knots 2 s
Ship with a speed of greater than 23 knots and changing
course
2 s
Table A-3: Reporting intervals for types of ship