User Manual
Table Of Contents
- Safety summary
- Preface
- Training information (for FCC approved equipment)
- Introduction
- Operation
- Overview
- General use and navigation
- Power on, speaker volume and antenna tuning
- SSB, AM BROADCAST, DSC or TELEX mode
- Radio settings and ITU channel selection
- Entering Rx and Tx frequencies
- Adjusting RF gain
- Soft-key functions
- Position and MMSI Information
- Channel information always available in the display
- Engagement status
- Speaker devices
- Changing the display colors and dim function
- Squelch on/off (soft key)
- Basic MF/HF radio communication
- Watch function
- DSC calls
- Phone book
- Radiotelex
- Replay function
- Setup
- Service & maintenance
- Glossary
- Index
Chapter 2: Operation
Phone book 35
2222
Operation
3. Press the soft key SAVE to save the contact information.
4. Press the soft key EXIT to leave the phone book.
Editing a contact
1. Press the soft key PHBOOK. If it is not in the display, press the soft key
MORE until PHBOOK appears.
2. Press the soft key EDIT.
3. Press and turn the selector knob to browse through the details of the
contact and continue as described in Adding a contact to the phone book
from step 2 onwards.
MMSI Turn and press the selector knob to enter the contact’s
MMSI number (9 digits), press the soft key OK to accept.
For coast station contacts you can also enter a DSC
channel.
Ch (optional) Press and turn the selector knob to select the preferred
channel for this contact, press the soft key OK.
Position Auto
Ack
For SHIP or COAST STATION: Press and turn the selector
knob to select YES or NO for this contact, press the soft
key OK. This will allow auto-ack of position requests for
this contact.
Listen to
Group
For GROUP: Press and turn the selector knob to select
YES or NO for this contact, press the soft key OK. The
radio will respond to calls to the specified group.
Contact Description