User Manual
Table Of Contents
- Safety summary
- Preface
- Training information (for FCC approved equipment)
- Introduction
- Operation
- Overview
- General use and navigation
- Power on, speaker volume and antenna tuning
- SSB, AM BROADCAST, DSC or TELEX mode
- Radio settings and ITU channel selection
- Entering Rx and Tx frequencies
- Adjusting RF gain
- Soft-key functions
- Position and MMSI Information
- Channel information always available in the display
- Engagement status
- Speaker devices
- Changing the display colors and dim function
- Squelch on/off (soft key)
- Basic MF/HF radio communication
- Watch function
- DSC calls
- Phone book
- Radiotelex
- Replay function
- Setup
- Service & maintenance
- Glossary
- Index
Chapter 2: Operation
Setup 37
2222
Operation
The recorded channel is displayed and the message length is shown in
seconds. The display shows also how old the message is. If the 240 s storage
limit is reached, the oldest data is overwritten.
Replaying recorded messages
Press the replay button to replay a recorded message. The latest message is
repeated. Information about this message is shown in the display. If a signal is
received while in replay mode the display shows in the display.
To stop replaying the message press the soft key STOP or the PTT button on
the speaking device. To rewind through one recorded message make a long
press on the Replay button. To leaf through all recorded messages press the
replay button repeatedly at short intervals.
Setup
The following setup pages are described in this section of the manual:
• Radio setup
• Channel setup
• Power Supply
• DSC setup
• DSC call logs
• System setup
• Controller setup
Note
The replay function can be started even in a Distress situation. If a
DSC call is received the replay function continues the playback.
Immediate acknowledgement of the DSC call initiates and activates
the DSC session. You can start replay from any session afterwards.