User Manual
Table Of Contents
- Safety summary
- Preface
- Training information (for FCC approved equipment)
- Introduction
- Operation
- Overview
- General use and navigation
- Power on, speaker volume and antenna tuning
- SSB, AM BROADCAST, DSC or TELEX mode
- Radio settings and ITU channel selection
- Entering Rx and Tx frequencies
- Adjusting RF gain
- Soft-key functions
- Position and MMSI Information
- Channel information always available in the display
- Engagement status
- Speaker devices
- Changing the display colors and dim function
- Squelch on/off (soft key)
- Basic MF/HF radio communication
- Watch function
- DSC calls
- Phone book
- Radiotelex
- Replay function
- Setup
- Service & maintenance
- Glossary
- Index
Chapter 2: Operation
38 Setup
Accessing a setup page
To change a setting in one of the SETUP pages, do as follows
1. Press the soft key SETUP. If it is not in the display, press the soft key MORE
until SETUP appears.
2. Press the arrow soft key or to advance to the SETUP page you want
to edit.
3. Turn the selector knob to go to a setting, then press the selector knob to
change the setting.
4. Press EXIT to return to normal radio operation.
Radio setup
Item Description
Scan
Hang
Time
Scan hang time, in seconds on an active receiving working channel.
The time is measured from the signal is detected. The radio remains on
the channel for the set time interval, if a signal was detected.
OFF: Resumes scanning when signal disappears (default)
4, 6, 8, 10: Hang time in seconds.
EXT. SSB
Mode
• OFF (default).
•ON
Use the mode SSB (EXT.) if you want to use the audio output on the
Transceiver Unit, for example to connect a modem.