User Manual
Table Of Contents
- Safety summary
- Preface
- Training information (for FCC approved equipment)
- Introduction
- Operation
- Overview
- General use and navigation
- Power on, speaker volume and antenna tuning
- SSB, AM BROADCAST, DSC or TELEX mode
- Radio settings and ITU channel selection
- Entering Rx and Tx frequencies
- Adjusting RF gain
- Soft-key functions
- Position and MMSI Information
- Channel information always available in the display
- Engagement status
- Speaker devices
- Changing the display colors and dim function
- Squelch on/off (soft key)
- Basic MF/HF radio communication
- Watch function
- DSC calls
- Phone book
- Radiotelex
- Replay function
- Setup
- Service & maintenance
- Glossary
- Index
Chapter 2: Operation
Setup 43
2222
Operation
Controller setup
Item Description
Handset 1 vol: Adjust earpiece volume for handset 1: ON, can be adjusted OFF and
from 5 to 100, in steps of 5.
Note: Default setting is ON. The handset connected to the front
connector has top priority and is configured to ON. The volume can
be adjusted from 0 to 100, in steps of 5.
Handset 2 vol: Adjust earpiece volume for handset 2: OFF, can be adjusted from 5 to
100, in steps of 5.
Note: Default setting is OFF. If a handset is connected to the rear
connector this value must be configured to a value (0 to 100, in steps
of 5).
High priority Yes — This MF/HF radio (Control Unit) can override the other Control
Unit connected to the same Transceiver Unit.
No — This MF/HF radio (Control Unit) cannot override the other
Control Unit.
Controller Info SW Version: Software version of the Control Unit
S/N: Serial number of the of the Control Unit
CU IP: IP address of the of the Control Unit