User Manual
Table Of Contents
- Safety summary
- Preface
- Training information (for FCC approved equipment)
- Introduction
- Operation
- Overview
- General use and navigation
- Power on, speaker volume and antenna tuning
- SSB, AM BROADCAST, DSC or TELEX mode
- Radio settings and ITU channel selection
- Entering Rx and Tx frequencies
- Adjusting RF gain
- Soft-key functions
- Position and MMSI Information
- Channel information always available in the display
- Engagement status
- Speaker devices
- Changing the display colors and dim function
- Squelch on/off (soft key)
- Basic MF/HF radio communication
- Watch function
- DSC calls
- Phone book
- Radiotelex
- Replay function
- Setup
- Service & maintenance
- Glossary
- Index
v
RF exposure hazards and instructions
Your Thrane & Thrane radio generates electromagnetic RF (radio frequency)
energy when transmitting. To ensure that you and those around you are not
exposed to excessive amounts of energy and thus to avoid health hazards
from excessive exposure to RF energy, all persons must obey the following:
Warranty limitation
The radio is not a user maintainable unit, and under no circumstances
should the unit be opened except by authorized personnel. Unauthorized
opening of the unit will invalidate the warranty.
Caution! Never touch the
Antenna Tuning Unit or
feeder wire when the
MF/HF radio is
transmitting. High
voltage which can cause
death or serious injury
is present at the
locations shown in the
illustration below.
Unit
Antenna Tuning
MF/HF
SAILOR 638x