Installation Manual

98-152675-A 5-1
Chapter 5
5555
Cobham Public
Special tools, fixtures and
equipment
5
For tools, fixtures and equipment necessary to perform the LGA-5005 installation
procedures described in this manual refer to Table 5-1, below. There are no Cobham part
numbers.
Note
Equivalent substitutes may be used.
Name
Specification or part
number
Source /CAGE code Section
1Torque
spanner
TNC, 15 mm (0.591"),
0.46 to 0.69 Nm (0.34 to
0.51 ft-lb)
Commercially
available
Installation of the
antenna on page 3-8 &
Removal of the
antenna on page 3-10
2Torque
driver 3
3.95 to 6 Nm (2.9 – 4.4 ft-
lb)
Commercially
available
Installation of the
antenna on page 3-8
3Phillips
bit
Size is #2. Commercially
available
Installation of the
antenna on page 3-8 &
Removal of the
antenna on page 3-10
4Flat
screw
driver
4-6 mm (0.16 - 0.24") Commercially
available
Installation of the
antenna on page 3-8
5 Tweezer Serrated tip, 120mm
(4.72")
Commercially
available
Removal of the
antenna on page 3-10
Table 5-1: Tools, fixtures and equipment required for the LGA-5005 installation
Item Name
Specification or part
number
Source
/CAGE code
Section
1 Non-curing
Mastic Sealant
Commercially available - Installation of the
antenna on
page 3-8
2 Isopropyl Alcohol Commercially available - -
Table 5-2: List of supplies