User's Manual

AVIATOR 200S/700S
User Manual
COBHAM PRIVATE
Document:
98-158752
Page:
77 of 105
Revision:
B
Level:
COM
CC:
1
(T: 99-161853-F)
Appendix D.3.1 Define Primary PDP Context
Define PDP Context. [3GPP_TS27]
Command
Possible response(s)
+CGDCONT=[<cid> [,<PDP_type>[,
<APN> [,<PDP_addr> [,
<d_comp> [,<h_comp> [,
<pd1> [,…[,pdN]]]]]]]]]
OK
ERROR
+CGDCONT?
+CGDCONT: <cid>, <PDP_type>, <APN>,
<PDP_addr>, <data_comp>,
<head_comp>[,<pd1>[,…[,pdN]]]
+CGDCONT=?
+CGDCONT: (range of supported <cid>s),
<PDP_type>,,,(list of supported
<d_comp>s),
(list of supported <h_comp>s)[,
(list of supported <pd1>s)[,…[,
(list of supported <pdN>s)]]]
Defined Values:
<cid>
(PDP Context Identifier) a numeric parameter which specifies a particular PDP context definition. The
parameter is local to the TE-MT interface and is used in other PDP context-related commands. The range
of permitted values (minimum value = 1) is returned by the test form of the command.
<PDP_type>
(Packet Data Protocol type) a string parameter which specifies the type of packet data protocol
IP Internet Protocol (IETF STD 5)
IPV6
20
Internet Protocol, version 6 (IETF RFC 2460)
PPP Point to Point Protocol (IETF STD 51)
<APN>
(Access Point Name) a string parameter which is a logical name that is used to select the GGSN or the
external packet data network. If the value is null or omitted, then the subscription value will be requested.
<PDP_address>
a string parameter that identifies the MT in the address space applicable to the PDP. If the value is null or
omitted, then a value may be provided by the TE during the PDP startup procedure or, failing that, a
20
IPv6 is not supported by the Inmarsat network.