User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 5: Using the web interface
98-122988-DraftB6 Setting up the interfaces 110
Configuring the WLAN interface
Note that the settings from the LAN window, except Enabled/Disabled, also apply for the WLAN
interface. See Configuring the LAN interface on page 107.
To configure the WLAN interface, do as follows:
1. Select SETTINGS > Interfaces > WLAN.
2. Select whether the WLAN interface should be Enabled or Disabled.
3. Select the Country code for your present location.
The list below explains the country codes.
Note
The country code must be entered before you can continue with the WLAN
configuration and/or use the WLAN interface.
Code Country
US USA
TW Taiwan
CA Canada
AT Austria
BE Belgium
CH Switzerland
DE Germany
DK Denmark
ES Spain
FI Finland
FR France
GB United Kingdom
GR Greece
HU Hungary
IE Ireland
IS Iceland
LI Liechtenstein
IT Italy
LU Luxembourg
NL Netherlands
NO Norway
PL Poland
PT Portugal
SE Sweden
JP Japan
IL Israel
SG Singapore
KR Korea
CN China
Code Country