User's Manual

Chapter 5: Using the web interface
98-122988-DraftB6 Setting up the interfaces 118
Configuring the Phone/Fax settings
Do as follows:
1. Select SETTINGS > Interfaces > Phone/Fax from the left navigation pane.
2. Select Enabled or Disabled to enable/disable the Phone/Fax interface.
3. Set the call type for incoming and outgoing calls.
Call types are described in more detail in Selecting the call type on page 51.
•For Incoming calls, you can check Standard or 3.1 kHz Audio or both.
If you check both, any device connected to the Phone/Fax interface will react (ring) on
incoming calls.
If you select e.g. Standard, the Phone/Fax interface will only react on calls made to the
Standard phone number.
•For Outgoing calls, you can select either Standard or 3.1 kHz Audio. The selected type will
be used by default, if possible, for any outgoing call. Note, however, that fax machines and
modems must use 3.1 kHz Audio.
4. Click Apply.
Note
You can override the default setting for outgoing calls by dialing 1* (force the call to
Standard) or 2* (force the call to 3.1 kHz Audio) before the number. For further
information, see Overriding the default outgoing call type on page 51.