User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 5: Using the web interface
98-122988-DraftB6 Administration 131
Defining filters for the Traffic Flow Template
To define the filters used in the Traffic flow template, do as follows:
1. From the left navigation pane, select
ADMINISTRATION > Traffic Flow Templates > Traffic flow filters.
Then fill in the details for each traffic flow filter as described below.
2. Type in an Evaluation Precedence Index in the Eval.Prec. Index column.
3. Fill in one or more of the following fields to define the filter.
The allowed ranges appear in hover text when you pass the mouse over the fields.
• Source address + Subnet mask.
• Protocol number.
• Destination port range (From and To). Note that Source and Destination are relative the
core network. This means that Destination is your EXPLORER™ 700 terminal.
• Source port range (From and To).
• Type of Service + Type of Service mask.
For further information on the principles and parameters of the Traffic Flow Template, refer to
the 3GPP standards TS27.007 V4.2.0 and TS 23.060 V4.7.0.
4. Click Apply at the bottom of the window.
The new settings are included if you select the filter in the Traffic flow template window.
Note
This field is mandatory. Each filter must have a different Evaluation Precedence
Index.