User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 6: Maintenance and troubleshooting
98-122988-DraftB6 142
A Bluetooth handset
connection cannot be
established.
The interface is disabled in
the EXPLORER™ 700.
Enable the interface by entering the
display menu system and selecting
SETTINGS > INTERFACES >
BLUETOOTH > ON, or
by accessing the web interface and
selecting SETTINGS > interfaces >
Bluetooth > Enabled
The Bluetooth handset is
placed too far away from
the EXPLORER™ 700.
Bring the handset closer to the
EXPLORER™ 700.
Note that the specified maximum
distance is only valid under ideal
conditions.
The handset is not yet
paired with the
EXPLORER™ 700.
Pair the devices. Refer to Making a call
to the EXPLORER™ 700 on page 58.
Incoming calls: The call
type used for the call is not
selected in the web
interface.
Make sure the call type used for calls to
the EXPLORER™ 700 is selected in the
web interface. Access the web interface
and select SETTINGS > Interfaces >
Bluetooth. Under BLUETOOTH VOICE
DEVICES locate the relevant handset
and select the right call type for
incoming calls.
A LAN connection
cannot be
established.
The interface is off in the
EXPLORER™ 700.
Enable the interface by entering the
display menu system and selecting
SETTINGS > INTERFACES > LAN >
ON, or
by accessing the web interface and
selecting SETTINGS > interfaces > LAN >
Enabled
The cable is not properly
connected.
Connect the cable.
The cable type or
connector type is not
correct.
For information on the correct type of
connector and cable, refer to LAN
interface, 2-port on page 158.
Problem Possible Cause Remedy