User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 6: Maintenance and troubleshooting
98-122988-DraftB6 145
A Bluetooth data
connection cannot be
established.
The interface is off in the
EXPLORER™ 700.
Enable the interface by entering the
display menu system and selecting
SETTINGS > INTERFACES >
BLUETOOTH > ON, or
by accessing the web interface and
selecting SETTINGS > interfaces >
Bluetooth > Enabled.
The computer is placed too
far away from the
EXPLORER™ 700.
Bring the computer closer to the
EXPLORER™ 700.
Note that the specified maximum
distance is only valid under ideal
conditions.
The computer is not yet
paired with the
EXPLORER™ 700.
Pair the devices. Refer to Making a call
to the EXPLORER™ 700 on page 58.
The requested Bluetooth
profile is not supported, or
is not activated on the
computer.
Check the Bluetooth installation on your
computer to see if the profile is
supported and activated.
You are using Bluetooth
and WLAN simultaneously
(WLAN mode 802.11b/g,
2.4 GHz)
Do not use Bluetooth and WLAN
simultaneously, or change the WLAN
mode to 802.11a (5 GHz) if possible.
Problem Possible Cause Remedy