User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Appendix A: Technical specifications
98-122988-DraftB6 155
Power input
Connector pin-out
This drawing shows the pin-out for the DC power
connector.
Specifications
AC/DC adapter, FSP 065-AAC
SIM interface
USIM #1 Specifications
USIM #2 Specifications
USIM #2 is reserved for future use.
+
GND
Item Specification
DC input range +10 to +32 V DC
Power consumption
a
Standby mode
Transmit mode
During charging
a. Performance depends on a wide range of factors and actual usage.
1.2 W (Typical)
18 W (Typical)
60 W max.
Connector type 2.5/5.5mm power jack, Switch craft RAPC 712
Item Specification
AC input range 100 to 240 V AC, 47 to 63 Hz, 65 W
DC output 19 V DC
Item Specification
Slot type Standard SIM card holder