User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Appendix B: AT commands
98-122988-DraftB6 170
List of supported AT commands
Command Function
ATA Answer
ATD Dial
ATE Command echo
ATH Hang up
ATI Request identification information
ATL Monitor speaker loudness
ATM Monitor speaker mode
ATN Automode control
ATP Select pulse dialing (command)
ATQ Result code suppression
ATS Set register
ATT Select tone dialing (command)
ATV DCE response format
ATX Result code selection and call progress monitoring control
ATZ Reset to default configuration
AT&C Circuit 109 (Received line signal detector) behavior
AT&D Circuit 108 (Data terminal ready) behavior
AT&F Set to factory defined configuration
AT&V Display active and stored profile
AT&W Store profile
AT+CACM Accumulated call meter
AT+CAEMLPP eMLPP priority registration and interrogation
AT+CALM Alert sound mode
AT+CAMM Accumulated call meter
AT+CAOC Advice of charge