User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 2: Getting started
98-122988-DraftB6 20
Powering the EXPLORER™ 700
Automatic power up
The default behavior of the EXPLORER™ 700 is to power up automatically when you connect the
power cable. If you wish, you can change this power up mode, so that the EXPLORER™ 700 is only
powered if the power button is pressed.
For further information on power up mode, see Setting the power up mode on page 40 or Power
up behavior on page 99.
Switching the EXPLORER™ 700 on/off
To switch on the EXPLORER™ 700,push the
Power button next to the display and hold it
down until the green Power indicator lights up.
It normally takes one or two seconds.
To switch off the EXPLORER™ 700, push the power button again and hold it until the display
shows SWITCHING OFF....
After switching on the EXPLORER™ 700 you will
be prompted for a PIN (Personal Identification
Number), unless the PIN is disabled (e.g. using
the BGAN LaunchPad)
For information on the options after power on, see the next section.
WARNING! When the EXPLORER™ 700 is powered on, stay clear of the antenna
front! The antenna emits radio frequency energy, not only when the display shows
DATA ACTIVE. Always keep a minimum distance of 1 m from the antenna front.
Power
button
Power
indicator