User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 3: Using the display and keypad
98-122988-DraftB6 36
Navigating the display and keypad
Navigating with the keypad
The PIN must be entered before you can access the menu system.
• To access the menu system from the Main screen, press S or T.
• To move up and down in the current menu, press S or T.
• To select the current menu item or setting, press OK.
• To escape the current menu/setting and return to the previous level, press C.
• To see the hidden part of long text strings, press X.
• To move backwards in the menu system, or in long text strings, press W.
• To adjust settings, press S and T.
Short-cuts
The following short-cuts are available in the menu system:
• To exit the menu system, press and hold C for one second. The display returns to the Main
screen.
• To activate/deactivate Stealth mode, Press C+OK.When stealth mode is activated, the display
shows STEALTH ACTIVATED for a moment; then all lights and sounds are turned off.
• To turn Pointing sound on/off, Press S or T from the pointing screen.
This action only applies to the current pointing session. To turn the sound on or off for all pointing
sessions, select
SETTINGS > AUDIO INDICATORS > POINTING and select ON or OFF.
Note
In low temperatures the display may respond slowly when a key is pressed. At
temperatures close to -25°C/-13°F the display may even turn black for a moment, e.g.
when you are scrolling through a menu. After 1-2 seconds with no keypad activity the
display will be readable again.
Note
For Stealth mode to be available, it must be enabled in the EXPLORER™ 700. Refer
to Enabling or disabling stealth mode on page 40.