User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 3: Using the display and keypad
98-122988-DraftB6 40
Enabling or disabling interfaces
Each interface (except USB) can be disabled to minimize the power consumption. Specially if the
EXPLORER™ 700 is battery powered, it is a good idea to disable unused interfaces.
To turn an interface on or off, select SETTINGS > INTERFACES and select one of the following
interfaces:
• PHONE/FAX
• BLUETOOTH
• LAN
• ISDN
• WLAN
Then select ON or OFF.
Enabling or disabling stealth mode
When the EXPLORER™ 700 is in stealth mode, all lights and sounds are turned off. You can still
use the EXPLORER™ 700, and the display text is readable.
To enable or disable the use of stealth mode, select
SETTINGS > STEALTH MODE and select one of the following:
• ENABLED
• DISABLED
To activate Stealth mode (after enabling Stealth mode), press C+OK on the keypad.
To deactivate Stealth mode, press C+OK again.
Setting the power up mode
By default, the EXPLORER™ 700 starts up automatically when you apply external power. You can
change this mode, so that you always have to press the power button to switch on the
EXPLORER™ 700.
To set the power up mode, select
SETTINGS > POWER UP MODE and select one of the following:
• AUTOMATIC: to have the EXPLORER™ 700 power up automatically when external power is
applied.
• MANUAL: to have the EXPLORER™ 700 power up only when the power button is pressed.
Note
Enabling stealth mode will not put the EXPLORER™ 700 into stealth mode, it only
enables the use of stealth mode.