User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 3: Using the display and keypad
98-122988-DraftB6 42
Properties menu
Viewing known Bluetooth devices
You can view a list of the Bluetooth devices that are paired with the EXPLORER™ 700. The devices
are listed with their Bluetooth names.
The devices in this list can communicate with the EXPLORER™ 700 without any further setup.
To view the list of known Bluetooth devices, select
PROPERTIES > BLUETOOTH DEVICES.
To see details on a specific Bluetooth device, select the device in the list and press OK.
Viewing the GPS status
The display can show the current GPS status.
To view the GPS status, select PROPERTIES > GPS STATUS.
The GPS status screen can vary, depending on the situation.
• If the GPS position has not yet been obtained,
the display shows the status of each of the 16
GPS satellites as follows:
• If the GPS position is known, the display
shows the GPS position, and whether it is a 2-
dimensional or 3-dimensional position (2D fix
or 3D fix).
• In some cases, the BGAN network does not
allow the position to be displayed to the user.
If this is the case, the display may just show
GPS ACQUIRED. This means that the GPS
position is received, but the user is not
allowed to see it.
This also applies if the EXPLORER™ 700 is not yet registered on the BGAN network, but the
GPS position is received.