User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 4: Using the interfaces
98-122988-DraftB6 Using a phone or fax machine 63
Sending or receiving a fax message
Handling delays
When sending or receiving fax messages over satellite, both fax units must be capable of handling
longer delays without timing out. Some fax machines have an Overseas mode, which enables the
unit to handle the long delays.
Sending a fax message
The fax machine must be connected to the Phone/Fax interface or the ISDN interface of the
EXPLORER™ 700. Refer to Before connecting to the Phone/Fax interface on page 53 or Before
connecting to the ISDN interface on page 54.
3.1 kHz Audio must be used for an analog fax machine. Refer to Selecting the default outgoing call
type on page 51.
UDI must be used for an ISDN fax machine, Refer to Configuring the ISDN interface on page 119.
To send a fax from a fax machine connected to the EXPLORER™ 700, dial
00 <country code> <phone number> #
Example: To send a fax to Thrane & Thrane in Denmark
(+45 39558888), dial 00 45 39558888 #
Receiving a fax message
An analogue fax machine connected to the EXPLORER™ 700 can only receive a fax with 3.1 kHz
Audio. Refer to Selecting the incoming call type on page 52.
An ISDN fax machine connected to the EXPLORER™ 700 can only receive a fax with UDI.
Make sure the fax is sent to the 3.1 kHz Audio phone number and that 3.1 kHz Audio or UDI is
enabled for the relevant interface.
Note
If the default setting in the web interface is not 3.1 kHz Audio, you can dial 2 * before the
number, to force the connection to use 3.1 kHz Audio. For further information, see
Selecting the default outgoing call type on page 51.