User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 4: Using the interfaces
98-122988-DraftB6 Using a computer 70
When you finish the wizard, the Thrane & Thrane EXPLORER™ USB driver is installed.
13. Create a dial-up connection as described in Using 64 kbps UDI (ISDN) through the USB
interface on page 70.
Connecting to the USB interface
This section does not describe configuration of the USB interface. For information on
configuration, see Configuring the USB interface on page 105.
If you are connecting your computer to the USB interface for the first time, see First time setup of
USB on page 69.
To connect to the USB interface, do as follows:
1. Power up your computer.
2. Connect the USB cable to the USB port of your computer.
3. Connect the other end of the
cable to the USB connector on
the EXPLORER™ 700.
4. Power up the EXPLORER™ 700 and point the antenna as described in Getting started on
page 12.
5. To enable communication on the USB interface, open your dial-up connection as described in
the following steps.
6. In Windows XP, select Connect To from the Start menu.
7. Select the dial-up connection created for this USB connection.
8. Click Dial and wait for the connection to be established. Then start your Internet browser or
mail program.
If connection fails, refer to the Troubleshooting Guide on page 144.
Using 64 kbps UDI (ISDN) through the USB interface
You can communicate using ISDN through the USB interface of the EXPLORER™ 700, provided that
your Internet Service Provider (ISP) supports Unrestricted Digital Information (UDI) and that it is
included in your subscription.
Note
The following description is for Windows XP. If you are using a different operating
system, the procedure may be different.