User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 4: Using the interfaces
98-122988-DraftB6 Using a computer 74
Creating a dial-up connection
Do as follows:
1. Start up your computer and the EXPLORER™ 700.
2. Connect the USB cable between your computer and the USB connector on your
EXPLORER™ 700, or place your paired Bluetooth computer close to the EXPLORER™ 700. For
information on Bluetooth, see Using a computer with Bluetooth on page 73.
3. On your computer, select Connect To from the Start menu.
4. Select Show All Connections.
5. Open the New Connection Wizard and click Next.
6. Select Connect to the Internet and click Next.
7. Select Set up my connection manually and click Next.
8. Select Connect using a dial-up modem and click Next.
If other modems are installed, you must select the Thrane & Thrane EXPLORER™ USB driver,
or the Bluetooth driver, from a list of modems.
9. In the ISP Name field, type a name for your connection and click Next.
10. When you are asked for a phone number, type:
*98# if you want a Standard data connection to the Internet and/or the web interface, or *99#
if you are going to connect only to the web interface of the EXPLORER™ 700.
To dial up using a specific Profile, type *98*<CID>#.
Note
The following description is for Windows XP. If you are using a different operating
system, the procedure may be different.