User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 4: Using the interfaces
98-122988-DraftB6 Additional interfaces 76
Additional interfaces
Using the EXPLORER™ 700 antenna
Before connecting the antenna
You can use the EXPLORER™ 700 with the antenna attached to the transceiver, or you can detach
the antenna from the transceiver and use it as a separate antenna unit.
If you are using the antenna attached to the transceiver, use the short antenna cable to connect
antenna and transceiver.
If you are using the antenna detached from the transceiver, use one of the antenna cables from
Thrane & Thrane, or a cable with the same specifications. For information on available lengths,
see Options and accessories on page 136. For specifications on the antenna interface, refer to
Antenna interface on Transceiver on page 162.
Connecting the antenna
Do as follows:
1. Connect the antenna cable to the connector
on the antenna module.
• If you are going to use the antenna and transceiver attached as one unit, use the short
antenna cable provided with your EXPLORER™ 700.
• If you are going to use the antenna separated from the transceiver, first open the terminal
and gently lift the transceiver out of the antenna frame. Then place the antenna in a
location with a clear view to the satellite and connect the antenna cable.
2. Connect the other end of the cable to the
antenna connector on the transceiver.
You are now ready to power up, enter PIN code and point the antenna of the EXPLORER™ 700.