User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
Chapter 4: Using the interfaces
98-122988-DraftB6 Additional interfaces 77
Using a solar panel
Before connecting
The EXPLORER™ 700 battery must be inserted when a solar panel is used. When the solar panel is
connected, it will supply the power to charge the battery of the EXPLORER™ 700.
To connect to the solar panel interface, use a suitable cable matching the output power of your
solar panel. For specifications on the solar panel interface, refer to Solar panel interface on
page 165.
Connecting a solar panel
Do as follows:
1. Make sure the battery is inserted.
2. Connect the cable to your solar panel.
3. Connect the other end of the
cable to the DC in connector on
the EXPLORER™ 700.
4. Point the solar panel directly towards the sun to obtain maximum power.
The battery is now charging.
The indicator left to the display is constantly green as long as the battery is charging. When the
battery is fully recharged, the green indicator is turned off. If the EXPLORER™ 700 is switched on,
the green indicator will be flashing shortly every 2 seconds.
If a charging error occurs, the green indicator on the EXPLORER™ 700 flashes rapidly. See the
Troubleshooting Guide on page 137.
Important
Avoid shadows from trees, buildings or similar. Shadows reduce the output
power of the solar panel significantly.