User's Manual
Table Of Contents
- Safety Summary
- Antenna Safety Instructions
- About the Manual
- Introduction
- Getting started
- Using the display and keypad
- Using the interfaces
- In this chapter
- General
- Bluetooth pairing
- Using a phone or fax machine
- Selecting the call type
- Connecting an analog phone or a fax machine
- Connecting an ISDN phone or a G4 fax machine
- Connecting a Bluetooth handset
- Entering the SIM PIN using a phone
- Making or receiving a phone call with the EXPLORER™ 700
- Making a call to the EXPLORER™ 700
- Dialing functions
- Sending or receiving a fax message
- Using a computer
- Additional interfaces
- What’s next?
- Using the web interface
- In this chapter
- Introduction
- The Home window
- Using the phone book
- Using the Call log
- Handling messages
- Setting up the EXPLORER™ 700
- Setting up the interfaces
- Enabling/disabling interfaces
- Description of data settings
- Configuring the USB interface
- Configuring the LAN interface
- Configuring the WLAN interface
- Configuring the Bluetooth interface
- Pairing Bluetooth devices from the web interface
- Configuring the Phone/Fax settings
- Configuring the ISDN interface
- Setting a common APN
- Properties, software upload and alarm list
- Administration
- Help desk and diagnostic report
- What’s next?
- Maintenance and troubleshooting
- Technical specifications
- In this appendix
- General specifications
- Battery
- Power input
- SIM interface
- Phone interface, 2-port
- ISDN interface, 2-port
- LAN interface, 2-port
- USB interface
- WLAN Access Point
- Bluetooth interface
- Antenna interface on Transceiver
- Detachable antenna
- EXPLORER™ Bluetooth Handset charger interface
- Solar panel interface
- I/O interface
- Serial number labels
- Conformity
- AT commands
- Glossary
- Index
98-122988-DraftB6 In this chapter 80
Chapter 5
Using the web interface 5
In this chapter
This chapter describes how to use the web interface to operate, set up and configure the
EXPLORER™ 700.
Initial configuration of interfaces is described in the chapter Using the interfaces on page 47.
Introduction
The web interface
What is the web interface?
The web interface is a built-in web server in the EXPLORER™ 700, used for operating, setting up
and configuring the EXPLORER™ 700.
You can access the web interface from a standard Internet browser.
Internet Explorer 6.0, Mozilla Firefox 1.0 and Apple Safari 2.0 have been tested successfully with
the web interface.
You may be able to use other browser versions as well.
Connecting
Connect your computer to the EXPLORER™ 700.
Make sure your computer is set up for the interface you are planning to use for connecting to the
EXPLORER™ 700. You can use LAN, USB, ISDN, WLAN or Bluetooth. See Using the interfaces on
page 47 for details.
To access the web interface, an Internet browser must be installed on the computer.
Important
If you are going to use USB or Bluetooth with Dial-up Networking to access only the
web interface and not the Internet, you must use a dial-up connection with the
phone number set to *99#. For further information, see Connecting to the USB
interface on page 70.