User's Manual
Table Of Contents
- Safety summary
- About the manual
- Introduction
- Getting started
- Operating the system
- Using the web interface
- Introduction
- Entering the SIM PIN in the web interface
- Using the Dashboard
- Using the phone book
- Using the Call log
- Handling SMS messages
- Setting up the interfaces
- Managing LAN network users
- Uploading software
- Selecting the preferred BGAN satellite
- Selecting the language
- Administration
- Help desk and diagnostic report
- Event logging and self test
- Site map
- Troubleshooting
- Conformity
- Glossary
- Index
Chapter 4: Using the web interface
98-131305-A Administration 118
3. At ALLOW AT COMMANDS ON:, select
• yes to allow the use of AT commands on the LAN interface, or
• no to block the use of AT commands on the LAN interface.
AT commands are low-level commands used to control modems, in this case the
EXPLORER 325 terminal. They are typically used during service and maintenance or when
troubleshooting the terminal.
4. Click Apply.
The settings to which access is denied are now greyed out for the non-administrator user.
Note
This setting does not take effect until the terminal is restarted.