User's Manual
Table Of Contents
- Safety summary
- About the manual
- Introduction
- Getting started
- Operating the system
- Using the web interface
- Introduction
- Entering the SIM PIN in the web interface
- Using the Dashboard
- Using the phone book
- Using the Call log
- Handling SMS messages
- Setting up the interfaces
- Managing LAN network users
- Uploading software
- Selecting the preferred BGAN satellite
- Selecting the language
- Administration
- Help desk and diagnostic report
- Event logging and self test
- Site map
- Troubleshooting
- Conformity
- Glossary
- Index
Chapter 4: Using the web interface
98-131305-A Administration 119
Remote management
You can set up the terminal so that it can be controlled from a remote location, either using the
web interface or AT commands.
To set up the terminal for remote management, do as follows:
1. From the left navigation pane, select ADMINISTRATION > Remote management.
2. Select whether remote access should be Enabled or Disabled for the web server and/or for AT
commands.
3. Type in the Incoming port numbers to use for the web server and for AT commands.
4. Under TRUSTED IP ADDRESSES, type in the IP addresses of the devices you want to give access
to the terminal.
5. Click Apply.
Note
The port number must be available at your service
provider. For AT commands, use 5454 if available. If 5454 is
not available you must use port forwarding to the port
number you are using.