User's Manual
Table Of Contents
- Safety summary
- About the manual
- Introduction
- Getting started
- Operating the system
- Using the web interface
- Introduction
- Entering the SIM PIN in the web interface
- Using the Dashboard
- Using the phone book
- Using the Call log
- Handling SMS messages
- Setting up the interfaces
- Managing LAN network users
- Uploading software
- Selecting the preferred BGAN satellite
- Selecting the language
- Administration
- Help desk and diagnostic report
- Event logging and self test
- Site map
- Troubleshooting
- Conformity
- Glossary
- Index
Chapter 3: Operating the system
98-131305-A Using a phone or fax machine 31
Transferring a call
When you receive a call, you can transfer this call to another phone connected to the terminal.
Thrane IP Handset:
Select Options > Transfer in the IP handset. For further details, refer to the section “Handling
calls” in the user manual for the Thrane IP Handset.
Analog 2-wire phones with R key:
Do as follows to transfer a call:
1. Press R 4 * <local number> #.
The phone with the local number you dialed starts to ring.
2. You now have two options.
• Hang up. The phone or headset you transferred the call to continues to ring. When the call
is answered, a connection is established between the initial caller and the new recipient.
• Do not hang up. When the new recipient answers, you can have a conversation before
hanging up. When you hang up, the call is handed over to the initial caller.
Note
Different types of phone have different methods/keys for the functions listed below. If you
have another type of phone than the ones listed below, refer to the documentation for
your phone/handset.