User's Manual
Table Of Contents
- Safety summary
- About the manual
- Introduction
- Getting started
- Operating the system
- Using the web interface
- Introduction
- Entering the SIM PIN in the web interface
- Using the Dashboard
- Using the phone book
- Using the Call log
- Handling SMS messages
- Setting up the interfaces
- Managing LAN network users
- Uploading software
- Selecting the preferred BGAN satellite
- Selecting the language
- Administration
- Help desk and diagnostic report
- Event logging and self test
- Site map
- Troubleshooting
- Conformity
- Glossary
- Index
98-131305-A iv
About the manual 2
Intended readers
This manual is a user manual for the EXPLORER 325 system. The manual is intended for
anyone who is using or intends to use this system. No specific skills are required to operate
the EXPLORER 325 system. However, it is important that you observe all safety
requirements listed in the beginning of this manual, and operate the system according to
the guidelines in this manual.
Most current version
This manual may not always reflect the latest software functionality of your EXPLORER 325
system. To obtain the latest version of the manual, please enter the Thrane & Thrane web
site www.thrane.com and download the latest version from Service > Self Service Center >
Downloads, or acquire it from your distributor.
Manual overview
Note that this manual does not cover installation nor does it cover how to use the IP
handset that comes with the system. For information on installation refer to the installation
manual and for information on the IP handset refer to the user manual for the IP handset.
Part numbers for both manuals are listed in the next section.
This manual has the following chapters:
• Introduction contains a brief description of the system and an overview of the BGAN
services.
• Getting started explains how to insert SIM (Subscriber Identity Module) card and start
up the unit. It also contains a short guide to making the first call.
• Operating the system explains how to use the system.
• Using the web interface explains how to use the built-in web interface of the terminal
for configuration and daily use, and describes the available menus and settings,
including advanced setup of interfaces.
• Troubleshooting contains a short troubleshooting guide and explains how to update
software. It also describes the functions of the light indicator and the Reset button, and
explains the event messages that may show in the web interface. Further, it gives
information on where to get help if needed.
• Conformity contains declarations of conformity for the EXPLORER 325 system.