User's Manual
Table Of Contents
- Safety summary
- About the manual
- Introduction
- Getting started
- Operating the system
- Using the web interface
- Introduction
- Entering the SIM PIN in the web interface
- Using the Dashboard
- Using the phone book
- Using the Call log
- Handling SMS messages
- Setting up the interfaces
- Managing LAN network users
- Uploading software
- Selecting the preferred BGAN satellite
- Selecting the language
- Administration
- Help desk and diagnostic report
- Event logging and self test
- Site map
- Troubleshooting
- Conformity
- Glossary
- Index
Chapter 4: Using the web interface
98-131305-A Setting up the interfaces 68
Configuring the Phone interface
To configure the Phone interface do as follows:
1. Select SETTINGS > Phone from the left navigation pane.
2. Set the call type for incoming and outgoing calls.
The call types are described in more detail in Selecting the call type on page 24.
•For Incoming calls, you can select Standard or 3.1 kHz Audio or both
1
.
If you select both, any device connected to the Phone interface will react (ring) on incoming
calls.
If you select e.g. Standard, the Phone interface will only react on calls made to the Standard
phone number.
•For Outgoing calls, you can select either Standard or 3.1 kHz Audio. The selected type will be
used by default, if possible, for any outgoing call. Note, however, that fax machines must
use 3.1 kHz Audio.
3. Click Apply.
1. Note that 3.1 kHz Audio is only available in elevations > 45°
Note
You can override the default setting for outgoing calls by dialing 1* (force the call to
Standard) or 2* (force the call to 3.1 kHz Audio) before the number. For further
information, see Overriding the default outgoing call type on page 25.