User's Manual
Table Of Contents
- Safety summary
- About the manual
- Introduction
- Getting started
- Operating the system
- Using the web interface
- Introduction
- Entering the SIM PIN in the web interface
- Using the Dashboard
- Using the phone book
- Using the Call log
- Handling SMS messages
- Setting up the interfaces
- Managing LAN network users
- Uploading software
- Selecting the preferred BGAN satellite
- Selecting the language
- Administration
- Help desk and diagnostic report
- Event logging and self test
- Site map
- Troubleshooting
- Conformity
- Glossary
- Index
Chapter 4: Using the web interface
98-131305-A Setting up the interfaces 80
Setting the call types for IP handsets
In the Call settings page you can set the call types for each local number and see whether
Restricted dialing is enabled for that number. For further information on Restricted dialing, see
Restricted dialing on page 122.
To set the call types for IP handsets, do as follows:
1. Select SETTINGS > IP handsets > Call settings.
2. For each handset, select the call types you want to enable for incoming and outgoing calls.
The call types are described in more detail in Selecting the call type on page 24.
•For Incoming calls, you can select Standard or 3.1 kHz Audio or both.
If you select both, the handset will react (ring) on any incoming call.
If, for example, you select Standard, the handset will only react on calls made to the
Standard phone number.
•For Outgoing calls, you can select either Standard or 3.1 kHz Audio. The selected type will be
used by default, if possible, for any outgoing call.
3. Click Apply.