Technical Manual
Table Of Contents
- Contents
- 1 Technical Specifications
- 2 Installation
- 2.1 Version Overview
- 2.2 Configuration of Single-Channel Unit
- 2.3 Cable Overview
- 2.3.1 Scanbus Termination
- 2.4 Where to Place the Satellite Transceiver Box
- 2.5 How to Mount the Satellite Transceiver Box
- 2.6 How to Put on the Finishing Cover
- 2.7 How to Insert the SIM Card
- 2.8 Optional SIM card Reader
- 2.9 How to Remove the Finishing Cover
- 2.10 Installation of the Antenna
- 2.11 Analogue telephone
- 2.12 Data Interface
- 2.13 External Ringer Interface
- 2.14 Reset Button
9
Installation
IRIDIUM
d
Press hard on the spots shown in the picture below until
a loud click is heard.
e
When putting on the finishing cover, do not use any tools
– only your hands.
2.7 How to Insert the SIM Card
First, open the small lid in the finishing cover protecting
the SIM card reader. Then go through each of the follow-
ing steps:
Unlock the SIM card holder by pushing the lock with your
finger nail.
c
0514
Lift the SIM card holder so that the slot points upwards.
d
Insert the SIM card in the slot. Make sure that the cut-off
corner of the card is placed as shown in the picture.
e
Push the SIM card holder back down, and lock it by
pushing the lock with a finger nail.
f
Finally, shut the lid again.