Technical Manual
Table Of Contents
- Contents
- 1 Technical Specifications
- 2 Installation
- 2.1 Version Overview
- 2.2 Configuration of Single-Channel Unit
- 2.3 Cable Overview
- 2.3.1 Scanbus Termination
- 2.4 Where to Place the Satellite Transceiver Box
- 2.5 How to Mount the Satellite Transceiver Box
- 2.6 How to Put on the Finishing Cover
- 2.7 How to Insert the SIM Card
- 2.8 Optional SIM card Reader
- 2.9 How to Remove the Finishing Cover
- 2.10 Installation of the Antenna
- 2.11 Analogue telephone
- 2.12 Data Interface
- 2.13 External Ringer Interface
- 2.14 Reset Button
Please note
Any responsibility or liability for loss or damage in connection with
the use of this product and the accompanying documentation is
disclaimed. The information in this manual is furnished for informa-
tional use only, is subject to change without notice, may contain
errors or inaccuracies, and represents no commitment whatsoever.
This agreement is governed by the laws of Denmark.
Doc. no.: M4150GB0 Issue: H/0514
Introduction
Your Iridium equipment is a modular system that consists of a
transceiver unit, control handset unit, antenna unit and an optional
analogue PSTN telephone/PABX.
You can make and receive voice calls on the control handset and the
analogue PSTN telephone. You can connect up to four handsets
and one analogue PSTN telephone or PBX switchboard to the
system.
The system provides intercom for internal calls between any control
handsets and between the analogue telephone and a control
handset.
Via the data port on the transceiver, the unit can be used as a data
modem for dial-up data calls, Internet access, SMS and E-mail
messaging.