Installation Guide

430 North Varney Street, Burbank, CA 91502
[phone]  Fax [phone]  www.trafficwks.com
INSTALLATION PROCEDURES FOR TD5200 SERIES
BOOMERANG™ SURFACE-MOUNT DELINEATORS USING
FIXED BASE BOLT-DOWN ANCHOR
To assemble post or sign on base:
1. Mount post over riser on base and insert two (2) hex bolts (¼”-20 x 2-½“)
through the post. Attach a washer and Nyloc nut to each bolt and tighten using
7/16” socket to snug bolts.
2. If sign or vertical panel is attached to post, the post must be removed from base
prior to the Boomerang reboundable base with fixed base plate being anchored
to the surface.
Please note the following prior to installation:
1. Pavement surface should be clean and dry prior to installation. Make sure all
dirt, dust (even fine dust), rocks, and/or gravel have been cleared from the
surface. For best results after sweeping, use compressed air to blow any fine
particles from the surface. The bottom of the base should also be clean of any
dust prior to installation.
2. Units are to be spaced evenly according to specifications required by the
instructions or manuals for each individual user, contractor, city, state or federal
agency. Bases manufactured by Three D Traffic Works, Inc. do not require
flame treating.
To install unit (assembled):
1. Our recommended anchor for each unit consists of 4 each of the following:
½ “ X 3” plastic or steel anchor
½ X 3 ½ “ Lag Screw
Metal Washer
2. Place Boomerang flexible base into bolt-down plate assembly on surface, and
align the desired position (direction you want the post/sign to face).
3. Using the base plate as a template, mark the four (4) holes to establish the
pattern for drilling.
4. Drill four (4) holes 3” deep using a ½” bit. Clean holes.
5. Using a small hammer, gently tap the anchors into the holes.
6. Place base over the embedded anchors and check for proper alignment.
7. Put washer onto the lag screw. Start lag screw through base hole into the
anchor. Use ¾” wrench to tighten lag screw into base.
8. After securing base to surface, place post, or post with attached sign/panel onto
the Boomerang reboundable base, check for proper alignment, and tighten the
two (2) hex bolts (¼”-20 x 2-½“) through the post and base riser using a 7/16”
socket to snug bolts.