Installation & Assembly (Oak)

In order to insert the Drawer (L), pull out the drawer glide to the end. Then, gently insert the drawer.

Attach the Door Knob (N) to the pre-drilled holes and tighten it with TH Screw (N) given using Screwdriver

(not provided).

Attach Anti-Tipping Kit (W) to wall. Attach Bracket (vertically) to wall using the Long Screw provided.

Attach Bracket (vertically) to furniture back (directly below top) with Short Screw. Place Bracket as close

to center of furniture back as possible in relation to wall stud and the desired position in the room. Move

furniture to its final position. Thread the strap through Bracket, and pull it tight.

Insert the Shelf Stud (T) to the pre-drilled holes at the Side Panel (C)&(D) and Center Panel (E)&(F) and

place the Shelf (J)&(K) following the note below.

CLEANING & CARE

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surface with a dry or

damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all

connections are tight.