Installation & Assembly

Turn The Server (A) upside down on a protective surface such as carpet or other soft
material. Remove the square block which screw at the four corner of Server Top. Turn
the screw anti-clockwise. See diagram below.
Insert Left & Right Center Vertical Panel (D) following the picture below and tighten
it with Flat Washer (K), Spring Washer (L) and JCBC Bolt (J) using Allen Key (N).
Push in the Back Panel (G) . Then insert V'ooden Dowel (O) at the bottom of both
Center Vertical Pane' (D).
Push in
2