Installation Guide

A) SPOUT INSTALLATION

1) Remove washer, lock nut and connect tee.

2) Apply plumbers’ putty or sealant.

3) Locate mounting hole and insert spout into deck or lavatory.

4) Screw and tighten washers, lock nut onto the shank and secure the spout

5) Insert pop-up rod into the spout.

6) Screw and tighten the connect tee to the shank.

7) Remove excessive plumbers’ putty or sealant.

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if necessary

B) HANDLE VALVE INSTALLATION

1) Place lower plastic washer and lock nut over valve body.

2) Insert valve body from under the sink.

3) Place upper rubber washers and escutcheon on valve spindle.

4) Adjust position of valve body. Secure valve body with lock nut and escutcheon.

5) Place handle onto spindle.

6) Tighten handle with screw.

TOOLS AND MATERIALS

LAVATORY FAUCET INSTALLATION GUIDE

PAGE 1
TOOLS AND MATERIALS LAVATORY FAUCET INSTALLATION GUIDE BEFORE YOU BEGIN 1) Shut off water supply. 2) Carefully inspect waste and supply tubing for signs of damage. 3) Replace waste or supply tubing if necessary A) SPOUT INSTALLATION 1) Remove washer, lock nut and connect tee. 2) Apply plumbers’ putty or sealant. 3) Locate mounting hole and insert spout into deck or lavatory. 4) Screw and tighten washers, lock nut onto the shank and secure the spout 5) Insert pop-up rod into the spout.
PAGE 2
C) FLEXIBLE HOSE INSTALLATION E) SUPPLY CONNECTION 1) Install flexible hoses onto hot and cold water outlets. 2) Secure hoses with wrench. Do not over tighten. 3) Connect flexible hoses to supply tee. 4) Circle the excessive part of hoses as shown in figure below . 1) Install lavatory according to manufacturer’s instructions. 2) Connect hoses (not provided) to angle stops. 3) Tighten all connections.