Owner Manual

18
100°
Step 4: Attach Swing End to Swing Beam
Warning: Glider
Hangers must be
tight and secure to
Swing Beams.
A: Place (4919) SW Rail Block in the centre between (1826) Front Beam and (1825) Back Beam and attach with
1 (H8) 1/4 x 4-1/4” Hex Bolt (with lock washer, at washer and t-nut). (g. 4.1 & 4.2)
B: Attach Swing Beam Assembly to the side of the Swing End Assembly with the overhang (g. 4.3 & 4.4) using
1 (G5) 5/16 x 4-1/2” Hex Bolt (with lock washer, at washer and t-nut) in the top hole of Triangle Plate and 1 (G8)
5/16 x 2” Hex Bolt (with 2 at washers and lock nut) in the bottom hole of T
riangle Plate. (g. 4.3) Make sure
Swing End Assembly ares out at an angle. (g. 4.4)
C: Attach 2 Glider Hangers to the Swing Beam Assembly using 2 (G7) 5/16 x 5-1/2” Hex Bolt (with 2 at washers
& lock nut) per Glider Hanger. (g. 4.1 & 4.3)
Glider
Hangers
Glider
Hanger
Wood Parts
Other Parts
Side with
overhang
1 x SW Rail Block 2 x 4 x 5-3/8”
4919
2 x Glider Hangers
Fig. 4.1
Fig. 4.2
Fig. 4.3Fig. 4.4
1/4” Flat
Washer
1/4” Lock
Washer
1/4”
T-Nut
H8
4919
G5
5/16” Flat
Washer
5/16”
Lock Nut
Hardware
1 x 1/4x4-1/4”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
1 x 5/16x4-1/2”HexBolt(5/16”lockwasher,5/16”atwasher,5/16”t-nut)
4 x 5/16x5-1/2”HexBolt(5/16”atwasherx2,5/16”locknut)
1x 5/16x2”HexBolt(5/16”atwasherx2,5/16”locknut)
H8
G5
G8
5/16” Flat
Washer
5/16” Lock
Washer
5/16”
T-Nut
5/16” Flat
Washer
5/16”
Lock Nut
G7
G8
G7
1826
1825