Owner Manual

20
Step 6: Monkey Ladder Assembly
C: Attach (1858) 1-1/8 x 18-5/8” Dowel to both posts with 2 (S2) #8 x 1-1/2” Wood Screws per dowel. One screw
is installed from top of the rails and the other from the bottom as shown in g. 6.3.
D: At bottom of (1367) Post MK attach (0353) MK Ground with 2 (H12) 1/4 x 3” Hex Bolts (with lock washer, at
washer and t-nut). Be sure to keep the bolts loose. (g. 6.3)
E: Make sure the assembly is square and then attach 1 (0369) Lower Diagonal to each end of (0353) MK Ground
with 1 (H2) 1/4 x 2” Hex Bolt (with lock washer, at washer and t-nut), keeping the bolts loose, and to each (1367)
Post MK with 1 (LS2) 1/4 x 2-1/2” Lag Screw (with at washer). Once lag screws are installed tighten all bolts from
Steps D & E. (g. 6.3)
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws and wood screws.
A: Insert 1 (1858) 1-1/8 x 18-5/8” Dowel into 2 (1367) Post MK as shown in g. 6.1.
B: Make sure shoulder of dowel is against each post before pre-drilling pilot
holes. Drill 1/8” pilot holes through the posts and into the dowel to prevent
splitting. (g. 6.2)
Wood Parts
Hardware
2x 1/4x3”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
2x 1/4x2”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
2x 1/4x2-1/2”LagScrew(1/4”atwasher)
2 x #8 x 1-1/2” Wood Screw
2 x Lower Diagonal 2 x 3 x 37”
1 x MK Ground 1 x 4 x 55-1/4”
2 x Post MK 2 x 3 x 70”
1x Tennon Dowel 1-1/8 x 18-5/8”
0369
S2
0353
1367
1858
LS2
H2
H12
0369
1367
0353
LS2
H2
S2
1367
1858
H2
LS2
1858
1367
Fig. 6.1
Fig. 6.3
1/4” Flat
Washer
1/4” Lock
Washer
1/4”
T-Nut
1/4” Flat
Washer
Fig. 6.2
1858
H12
0369
Make sure not to over
tighten or strip lag
screws.