Owner Manual

24
Step 9: Window Side Wall Assembly
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws.
A: On the ground lay at 2 (1931) Posts then attach (1932) Side Ground with 4 (H2) 1/4 x 2” Hex Bolts (with lock
washer, at washer and t-nut); (1934) End Floor using 2 (H2) 1/4 x 2” Hex Bolts (with lock washer, at washer
and t-nut) in the bottom holes; and (1935) Side Roof using 2 (H2) 1/4 x 2” Hex Bolts (with lock washer, at
washer and t-nut) as shown in g. 9.1. Notice the longer extended end on (1935) Side Roof is on the same side
as the extended end of (1932) Side Ground. Keep bolts loose.
B: Make sure assembly is square and then fasten (1934) End Floor to (1931) Posts in the top holes using 2
(LS1) 1/4 x 1-1/2” Lag Screws (with at washer). (g. 9.2)
C: Tighten all bolts.
Notice the hole
locations of (1934)
End Floor
Notice overhang
on this side
Wood Parts Hardware
8x 1/4x2”HexBolt(1/4”lockwasher,1/4”atwasher,1/4”t-nut)
2x 1/4x1-1/2”LagScrew(1/4”atwasher)
1 x End Floor 1 x 5 x 35-1/4”
1 x Side Ground 1 x 5 x 50-1/4”
2 x Post 2 x 4 x 81”
1 x Side Roof 1 x 4 x 55-1/8”
1934
1935
1931
1932
LS1
H2
H2
1931
1934
1935
1932
1931
Fig. 9.1
Fig. 9.2
1934
1931
1931
Notice long extension on this side
1/4” lock
washer
1/4” at
washer
1/4” t-nut
1/4” at
washer
LS1
H2
H2